Pin EN1 Motor Driver - > Pin 8 ARDUINO UNO Pin IN Motor Driver - > Pin 9 ARDUINO UNO Pin 5V Motor Driver - > Pin5v ARDUINO UNO GND Motor Driver Pin - > GND Lipo Batery + Gnd Arduino Pin 12V Motor Driver - > VCC Lipo Battery Gnd pin DC motor - > mot pin 2 Motor Driver (can be changed as desired) VCC pin DC motor - > mot pin 1 Motor Driver (can be changed as desired) To set the rotational speed of the DC motor It takes a driver motorbike that is connected to Arduino, the motor driver must be given an input voltage of 5v and 12v for a voltage of 5V we take from Pin Arduino While 12 comes from LiPo batteryįor sensors used in this system we use LM35, this sensor has 3 foot pins, VCC, Ground, and data sensor inside, for flexing sensors you can place as you like in this case we store it right behind the propeller. In designing electronic systems or hardware components needed include:įor Lifa and Lvifa Base can be downloaded Master Program.rarĪfter all the components are available, the next thing is to make a room prototype, here we make a room with the size of 17X17 cm by placing an incandescent lamp in the middle of the room which serves as the temperature effector of the system. N making PID-based room temperature control systems using Labview there is a design that must be done starting with the design of PID controls using Labview, and electronic system design.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |